Vermont-casting P Manuel d'utilisateur télécharger pdf (Page 5)

20007967

NOTE: Your gas log set is assembled at the factory to be installed in a ﬁreplace plumbed with the gas on

the right side (facing). If your ﬁreplace is plumbed with the gas on the left side remove ﬁttings on right and

left side of straight burner tube and switch sides, at the same time put front burner tube on right side with

the elbow ﬁtting. (Refer to Figs. 3,4)

You may also run a ﬂexible connector (or as per local codes) along the back wall of the ﬁreplace to bring

your gas line to the right hand side. You can then place the set in front of the ﬂexible connector. (Fig. 4)

Gas Plumbed on Left Hand Side of Fireplace

CFM149

R-CFL Gas Supply Connection

2/14/01 sta

CFM149

Fig. 2 Natural gas connection.

4. Attach one end of the Flexible Gas Connector to

the brass Burner Inlet Fitting which has been factory

installed into the burner.

5. Attach the other end of the Gas Connector to the

ﬂared side of the Gas Supply Fitting.

Remember to use pipe thread sealant or teﬂon tape

only on the straight pipe threads. Do not use on

any ﬂared ends.

FP1484

OD24SHK

LP hook up

5/04 djt

Rigid Pipe. Flexible Hose or Copper Tubing

Approved for Outdoor Use

Gas Inlet 3/8”

Pipe Coupling

Parts Not

Supplied

Flex Hose

Regulator

Supplied w/LP Unit

FP1484

Fig. 3 LP gas connection.

To Gas Supply

3/8” Brass Elbow

NPT to Flare

FP1486

alternate left

side gas connection

5/10/04 djt

Fig. 4 Alternate left side gas connection.

FP1486FP1485

FP1485

alternate left side

gas connection

5/10/04 djt

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Vermont-casting P Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Four Vermont-casting P